Tie rod boots

Home Page Forums Chassis Tie rod boots

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #392418

    I don’t know if anybody else thinks the aftermarket tie rod boots are a pos but I happened across these Polyurethane boots made by Energy Suspension. They need to be cut down to 3/4″ because they are for a Chrysler torsion bar and way too long to use as is.

    There are several #s on the label so I’ll give them all.

    5.13101G

    903323

    03639 36821 and

    13022

    It says Chrysler Torsion Bar Dust Boot. After I cut them to length the stock spring seat fit on the top and I didn’t use the spring. They seal very tight and seem really tough. I have a 1930 Mod B so I don’t know what other years they would work on. Jim L”

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.