Tappet gallery attachment

Home Page › Forums › Engine › Tappet gallery attachment

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 12, 2019 at 3:17 pm #392840
    Author nameAuthor names are only available to PAS members.

    I am trying to figure out the method of attachment of the 2 tappet gallery covers. They appear to be a stud and ????. Just a nut?, a special nut? or something else. Or is it a long bolt?

    December 12, 2019 at 5:12 pm #411384
    Author nameAuthor names are only available to PAS members.

    A long stud with decorative acorn nut was used to help seal the covers over a cork gasket around the perimator.

    December 12, 2019 at 10:15 pm #411386
    Author nameAuthor names are only available to PAS members.

    David,

    Great, thank you.

    Bill

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.