’33 Stewart-Warner power unit

Home Page › Forums › General › ’33 Stewart-Warner power unit

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • July 30, 2021 at 9:50 am #466600
    Author nameAuthor names are only available to PAS members.

    Need seals for output shaft, both sides. I’ve checked tech pages and tried Olcar but nobody picks up. Anyone have a source and part numbers ?

    August 1, 2021 at 1:08 pm #466614
    Author nameAuthor names are only available to PAS members.

    Frank,

    Olcar has passed on. I may have the numbers on them. I am out of town and will check when I get back.

     

    Bill

    August 2, 2021 at 7:25 am #466638
    Author nameAuthor names are only available to PAS members.

    I was going to use CR-11776, which appears to be the correct OD/ID but are about 1/2 the thickness of the original. I was thinking of possibly using 2 back to back.

    Here is a tool to help find seal numbers.

    CR Seal Finder (skfextranet.com)

    August 2, 2021 at 7:50 am #466639
    Author nameAuthor names are only available to PAS members.

    Thanks Bill, I will check with them and welcome home !

    August 2, 2021 at 8:00 pm #466661
    Author nameAuthor names are only available to PAS members.

    I put in Napa 18785 in the rear of the power brake unit.  According to my notes.  But the boxes day 21267. I just have used them on both the front and rear.

     

     

    August 4, 2021 at 7:12 am #466835
    Author nameAuthor names are only available to PAS members.

    Thanks Doug, I will be headed to Napa this weekend ! I appreciate your help, Frank.

    August 4, 2021 at 6:23 pm #466846
    Author nameAuthor names are only available to PAS members.

    Frank, I did all the work on my 1933 1247 so if I can help with any questions please don’t hesitate to ask.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.