Reply To: Engine assembly sequence

Home Page › Forums › Engine › Engine assembly sequence › Reply To: Engine assembly sequence

February 1, 2021 at 8:17 am #426987
Author nameAuthor names are only available to PAS members.

All the rods and pistons are assembled. I went back and measured the width of the slot in the rod.

At the big end side it measured .133″ and at the pin end measured .129.  There goes your pin clearance.

I started cleaning out the smaller galleries. I started with a .25 caliber gun brush and that did nothing. Move up to a .30/.32 and that seems the correct size.